Untitled

SAFETY DATA SHEET
TREADFAST MVS RAPIDE
1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND COMPANY/UNDERTAKING Component of a self-curing acrylate deck coating system Tremco illbruck Production LimitedCoupland RoadHindley GreenWigan WN2 4HTEnglandTel : +44 (0)1942 258011Fax : +44 (0)1942 521923email : [email protected] Irritating to eyes, respiratory system and skin.
May cause sensitisation by skin contact.
The Full Text for all R-Phrases are Displayed in Section 16 Provide rest, warmth and fresh air. Place unconscious person on the side in the recovery position and ensure breathing If breathing stops, provide artificial respiration. Get medical attention if any discomfort continues.
INGESTION Rinse mouth thoroughly. DO NOT induce vomiting. Get medical attention immediately.
Promptly wash contaminated skin with soap or mild detergent and water. Promptly remove clothing if soaked through and wash as above. Get medical attention if irritation persists after washing.
EYE CONTACT Rinse the eye with water immediately. Continue to rinse for at least 15 minutes and get medical attention.
TREADFAST MVS RAPIDE
Use supplied air respirator if product is involved in a fire. Use water SPRAY only to cool containers! Do not put water on leaked material.
Forms explosive mixtures with air. May travel considerable distance to source of ignition and flash back. Fire causes formation of toxic gases.
Wear protective clothing as described in Section 8 of this safety data sheet.
Spillages or uncontrolled discharges into watercourses must be IMMEDIATELY alerted to the Environmental Agency or other appropriate regulatory body.
SPILL CLEAN UP METHODS Stop leak if possible without risk. DO NOT touch spilled material! Extinguish all ignition sources. Avoid sparks, flames, heat and smoking. Ventilate. Inform Authorities if large amounts are involved. Absorb in vermiculite, dry sand or earth and place into containers.
Keep away from heat, sparks and open flame. Ventilate well, avoid breathing vapours. Use approved respirator if air contamination is above accepted level.
STORAGE PRECAUTIONS Store in tightly closed original container in a dry, cool and well-ventilated place.
Respiratory protection must be used if air contamination exceeds acceptable level. Use chemical cartridge protection with appropriate cartridge.
HAND PROTECTION Wear splash-proof eye goggles to prevent any possibility of eye contact.
Wear antistatic, flame retardant protective clothing and antistatic boots.
¹ Information given concerns the major ingredient.
TREADFAST MVS RAPIDE
Avoid heat, light & moisture. Possibility of strongly exothermal polymerisation on exposure to heat or catalysing substances. Polymerisation may cause pressure build-up and bursting of drums Polymerisation may be checked by cooling or adding an inhibitor such as hydroquinone.
MATERIALS TO AVOID Organic peroxides/hydroperoxides. Strong oxidising substances. Strong reducing agents.
Relatively low toxicity. Odour threshold is well below occupational exposure limit.
Irritating to skin. May cause sensitisation by skin contact.
Waste product is classified as Hazardous Waste Contaminated rags etc are also hazardous waste, as are uncleaned cans.
In the UK refer to the Hazardous Waste Regulations (2005) TREADFAST MVS RAPIDE
2-HYDROXYETHYL METHACRYLATEETHYLENE DIMETHACRYLATEMETHYL METHACRYLATE Irritating to eyes, respiratory system and skin.
May cause sensitisation by skin contact.
Keep container in a well-ventilated place.
Keep away from sources of ignition - No smoking.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Take precautionary measures against static discharges.
Chemicals (Hazard Information & Packaging for Supply) Regulations 2002 Dangerous Preparations Directive 1999/45/EC NOTE: Lines within the margin indicate significant changes from the previous revision.
Irritating to respiratory system and skin.
May cause sensitisation by skin contact.
SAFETY DATA SHEET
TREADFAST MVS RAPIDE INITIATOR
1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND COMPANY/UNDERTAKING Accelerator for self-cure acrylic systems Tremco illbruck Production LimitedCoupland RoadHindley GreenWigan WN2 4HTEnglandTel : +44 (0)1942 258011Fax : +44 (0)1942 521923email : [email protected] May cause sensitisation by skin contact.
The Full Text for all R-Phrases are Displayed in Section 16 Fresh air. Get medical attention if any discomfort continues.
DO NOT induce vomiting. Get medical attention immediately.
Wash the skin immediately with soap and water. Get medical attention if any discomfort continues.
Rinse the eye with water immediately. Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues.
DO NOT use halogenated extinguishing media.
TREADFAST MVS RAPIDE INITIATOR
Emits oxygen easily and may cause fire or explosion if heated. Explosively reactive with many materials. May ignite other combustible materials.
Avoid dust formation. Keep combustibles away from spilled material. Collect into sealed non-metallic container Containers with collected spillage must be properly labelled with correct contents and hazard symbol. Flush with plenty of water to clean spillage area.
Keep away from heat, sparks and open flame. Do not use tools which may generate sparks. Avoid handling which leads to dust formation.
Store in tightly closed original container in a dry, cool and well-ventilated place. Store separated from: Reducing Agents. Alkalies. Keep in original container.
If ventilation is insufficient, suitable respiratory protection must be provided. Use specified dust masks.
Protective gloves and goggles must be used if there is a risk of direct contact or splash.
Risk of self accelerating decomposition above 60°C Acids. Alkalis. Reducing agents. Iron oxides. Containers and equipment should be pvc, polyethylene or glass May cause sensitisation by skin contact.
TREADFAST MVS RAPIDE INITIATOR
Dangerous for the environment if discharged into watercourses.
Contains phthalates which have a high potential for bioaccumulation.
Waste product is classified as Hazardous Waste In the UK refer to the Hazardous Waste Regulations (2005) ORGANIC PEROXIDE TYPE D (DIBENZOYL PEROXIDE) 50 Oxidising (fire-intensifying) substance.
May cause sensitisation by skin contact.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
TREADFAST MVS RAPIDE INITIATOR
Risk of explosion by shock, friction, fire or other sources of ignition.
May cause sensitisation by skin contact.

Source: http://www.tremco-illbruck.es/celumdb/documents/Treadfast_MVS_Rapide_MSDS_GB_7158.pdf